ANY SOFTWARE

AnyCasting Software would like to bring you the release of AnyCasting Version 6.7.
Through the development new features and strengthening our software, we hope to bring solutions to the problems in casting and greater accuracy in predicting shrinkage defects.
Please refer to below and our homepage for more details.

• Simple Gate
- Create an ingate for optimal runner design

• Multi Phase Vacuum
- Observe accurate vacuum effect through equipment-based vacuum settings

• Soldering Sensitivity
- Predict soldering considering mold release resistance during ejection

• Counter Pressure Casting
- New casting process simulation using counter pressure

• Vent System
- Set Pin/Slit type vent and observe pressure and gas input/output through vent

• Casting Defect Based GUI
- New result GUI based on each process

• Improved RealShape
- All Entities can be created into RealShape

• Real Cycle Setting
- Able to set Cycle settings realistically like actual process

• Improved Core Gas Accuracy
- Better Core Gas accuracy by variety of parameter settings and Gas output effect

• Improved Latent Heat
- Accurate solidification simulation regarding Fs-T Curve

• Added Unit System
- Added Imperial Unit